Working on the Ruger Mini-14 gas block should not be part of routine maintenance, however, when that time comes you need a plan, and perhaps a special tool, to make the job go smoothly.
by John Baxter
Read the rest of this entry »
Shop-Made Mini-14 Gas Block Wrench
June 25, 2014 — John M. Buol Jr.Assessing Barrel Wear, Part One
June 20, 2014 — John M. Buol Jr.While more like reading tea leaves than hard science, there are clues in determining barrel wear.
by Joe Carlos
Read the rest of this entry »
Reshaping Too Large Cheek Pieces
June 15, 2014 — John M. Buol Jr.How to create a better looking rifle stock, whether it’s a two piece or standard.
by Dominick Pisano
Read the rest of this entry »
Building The 90 Grain AR-15, Part Three
June 10, 2014 — John M. Buol Jr.An overview of projectiles and loads for heavy bullet .223/5.56 AR-15s.
by Joe Carlos
Read the rest of this entry »
Precision Barrel Fitting, Part Three
June 5, 2014 — John M. Buol Jr.Why squaring the receiver face is mandatory before joining it to a barrel.
by Chick Blood
Read the rest of this entry »
Old Technology, Stale Designs, Part One
June 1, 2014 — John M. Buol Jr.An editorial by Paul Mazan.
Read the rest of this entry »
